Shenzhen Puzhesi Technology Co., Ltd.  

Product Name: Optical Chamber 4-Wire Smoke Detector with Relay Output Model NO.: PZ-05 Application: Home, Communication Electronic Products Certification: CE, RoHS, CCC Installation Mode: Ceiling Mounted Type: Smoke Alarm Weigt: 155g Alarm Type: Sound Light Color: White Power: DC9V-28V Degree: Zreo Ten Degree to 50 Degree Trademark: alarm Transport Package: Catton Specification: 103*103*55mm Origin: China Product Description The detectors are photo-electronic detector uses a state of-the-art optical sensing chamber. This detector is designed to provide open area protection and to be used with most security alarm control panel.Two LEDs on each detector provide local 360° visible alarm indication. They flash every six seconds indicating that power is applied and the detector is working properly. The LEDs latch on in alarm. LEDs will be off when a trouble condition exists indicating that the detector sensitivity is outside the listed limit. The alarm can be reset only by a momentary power interruption.The detector that initiated the alarm condition will have its red LED and relays latched until reset by panel.Heat detector and smoke & heat detector combine a photo electronic sensing chamber and a temperature heat detector.2. SPECIFICATIonSOperating Voltage Range: 9 to 28 VDC Volts Non-polarizedStandby Current: ≤200µAMaximum Alarm Current (LED on): ≤45mAAlarm Relay Contact Ratings: 2A@ 24V DCOperating Humidity Range: ≤95%RH(40°C±2°C) Relative Humidity, Non-condensingOperating Temperature Range: -10°C to 50°C (14°F to 122°F)Smoke Alarm Sensitivity: 1.06±.26%FTWARNINGTO PREVENT DETECTOR ConTAMINATION AND SUBSEQUENT WARRANTY CANCELLATION, THE SMOKE DETECTOR MUST REMAIN COVERED UNTIL THE AREA IS CLEAN AND DUST FREE.3. INSTALLATIONNOTE: All wiring must conform to applicable local codes, ordinances, and regulations.INSTALL THE DETECTOR base1. Open area smoke or heat detectors are intended for mounting on a ceiling or a wall in accordance with the fire standard in your country.2. Attach mounting base to ceiling or wall. The base of the detector can be mounted directly onto an electrical junction box such as an octagonal (75mm, 90mm or 100mm), a round (75mm), or a square (100mm) box without using any type of mechanical adapter.3. Position all wires flat against terminals, and fasten the wires on the terminals,